WCTSP
Step 3 |
|
Cartridge
Height Measurement and Finding VTA Reference Point. |
|
3.1  |
|
| Picture 3.1: Special milimeter gauge is used to measure the height of the cartridge. It shows 20.5 mm cartridge height. | |
3.2  |
|
| Picture 3.2: Use Wally VTA Gauge with the right amount of spacers to match the cartridge height : 16 + 3 + 1.0 + 0.5 mm = 20.5 mm | |
3.3  |
|
| Picture 3.3: Install Wally VTA Gauge with required spacers and locate it on the record. Picture shows that Arm Bearing is located too high. | |
3.4  |
|
| Picture 3.4: The Arm Bearing is located below Reference Point | |
3.5  |
|
| Picture 3.5: Picture shows that Arm Bearing is located at VTA Reference Point. | |
3.6 coming soon
|
|
|
Picture
3.6: Take readouts from VTA Dial for VTA Reference Points : - one for the thinest record. - one for the thickest record from your collection |
|
| Previous | |